Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly togethe...
Revell Contacta Professional for precise gluing. With the needle-fine cannula, micro-precise bonding can be carried out on tiny details and on the edges of transparent parts.
Special properties:
...
Tamiya Extra Thin Cement is a widely popular glue among modelers around the world. You will find it in most modeler’s workshops. This version is the “quick setting” variant that dries around 4 time...
This cement is for use in assembling plastic (styrene) models. It comes in a stable 4cm square bottle which is 3.5cm tall and contains 40ml of cement. The cap has a brush on the reverse side for si...
Maxi-Cure™ extra thick CA is the best CA for most plastics, including GE’s Lexan MAXI-CURE™ is the best choice for plastic model assembly. When used with INSTA-SET™, it works better than any putty ...
Revell Contacta Professional for precise bonding. With the needle-fine cannula, micro-precise bonding can be carried out on tiny details and on transparent part edges.
Insta-Cure+™ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly togethe...
No crevice is too small for this flowing adhesive, which was developed to flow into and stick the small spaces between two plastic parts which have been pre-fitted to one another. The 40ml bottle f...
NSTA-SET™ is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET™ in a spray bottle is norm...
Tamiya Basic Type Putty is used for filling in seams when assembling plastic model kits or RC models that use ABS or styrene plastic bodies. The putty is gray in color and may be applied with a fla...
SUPER-GOLD™ Thin and SUPER-GOLD+™ gap filling medium thickness are our odorless foam safe CAs. They are non-frosting and take only 2 or 3 seconds longer to bond compared to Insta-Cure and Insta-Cur...
Revell Contacta Clear is a special crystal clear adhesive for model making. It is an aqueous adhesive that is overall suitable for different types of plastics. When dried, it has a high degree of t...
This cement is for use in assembling plastic (styrene) models. It comes is a stable hexagonal bottle 47mm tall.
Contents: 20ml.
Features a brush for application on the reverse side of the cap.
Wor...
