Replace or duplicate your Power Cab's plug-in point with the PCP panel.
Connection panel (Power Cab Panel) that the Power Cab plugs into: it distributes power to the track and provides the cab bus ...
Add a dedicated programming track and a computer interface to your Power Cab with the Power Cab Partner.
Compact accessory (NCE micro case) providing a dedicated programming-track output, a built-i...
Update your Power Cab throttle with the NCE version 1.65B firmware chip.
Memory chip (EPROM) that replaces the one in the Power Cab to bring its firmware to version 1.65B: it adds the fixes and imp...
Round out your DCC detection and signalling circuits with NCE 2700 ohm resistors.
1/8 watt resistors supplied in a pack of 20, useful for current limiting, occupancy detection and signalling circui...
Round out your DCC detection and signalling circuits with NCE 3300 ohm resistors.
1/8 watt resistors supplied in a pack of 20, useful for current limiting, occupancy detection and signalling circui...
Turn your Power Cab into a walk-around operating system with the NCE SB5 Smart Booster.
The SB5 acts as a command station and 5-amp booster; plugged into the SB5, the Power Cab works like a ProCab ...
Control your turnouts in DCC with the NCE Snap-It accessory decoder.
Capacitive-discharge stationary decoder that drives a twin-coil ("snap") solenoid switch machine such as Atlas, Peco or Bachmann...
Clean up the DCC signal on long bus runs with the NCE Snubber noise suppressor.
RC filter to fit at the far end of a long track bus: it damps the noise and reflections that can cause loss of contro...
Get your DCC layout wiring started with the NCE all-in-one kit.
Complete set combining a 25' (7.6 m) main power bus, feeder wires, connectors and track bus taps: everything to wire a small DCC layo...
